The first layer is the foundation of the part. If it is wrong, peeling, warping and a rough bottom surface usually follow.

What a good first layer looks like

Lines lie tightly side by side and are slightly flattened, with no gaps and no ridges between them. The surface is uniform and smooth to the touch.

Nozzle too far

  • gaps between the lines;
  • weak bonding between lines and to the bed;
  • the layer peels off easily.

Nozzle too close

  • wavy, rough surface;
  • ridges rising between the lines;
  • scraping noise or scratches on the plate.

How to start calibrating

  1. Clean the nozzle and the bed: a blob of old plastic on the nozzle tip is measured as the bed.
  2. Preheat the bed and hold the target temperature for 10–15 minutes.
  3. Run auto-calibration. On Bambu Lab printers this is Auto Bed Leveling in the Calibration menu, plus High-temperature Bed Leveling for ABS, ASA and PA. Prusa offers a first-layer calibration wizard and Live Z adjustment.
  4. Print a test: MakerWorld has many free first-layer and bed-adhesion test models.
  5. Adjust the Z offset by a few hundredths of a millimetre and repeat.

Do not compensate for weak adhesion by lowering Z as far as possible: Prusa says this is not a solution. Check surface cleanliness, bed temperature and first-layer speed instead. See also Why your print won't stick to the bed.

Sources